If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Protection
I have setup a workbook and selected certain cells to be protected. After creating a password protection for the workbook I saved it and turned it loose to the users.
Now I have a user that has Disabled the UNPROTECT option....it is always grayed out for me. So how was this done? And how do I undo this? |
#2
|
|||
|
|||
Protection
Thee user may have set workbook sharing on under Tools, Share Workbook.
-- Jim Rech Excel MVP "BenJAMMIN" wrote in message ... |I have setup a workbook and selected certain cells to be protected. After creating a password protection for the workbook I saved it and turned it loose to the users. | | Now I have a user that has Disabled the UNPROTECT option....it is always grayed out for me. | | So how was this done? | And how do I undo this? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Excel 2000 vs 2002 Sheet protection & Validation cells | Andre Croteau | General Discussion | 4 | July 17th, 2004 03:31 PM |
Shape protection and/or layer properties prevent the complete exec | mryuck | Visio | 0 | July 16th, 2004 08:01 PM |
Multiple Worksheet protection | K. Georgiadis | General Discussion | 5 | June 21st, 2004 05:29 PM |
Excel 2000 - Worksheet Protection Problem | Norman Harker | Worksheet Functions | 1 | February 18th, 2004 08:58 AM |
Protection | Ralph | Worksheet Functions | 1 | October 28th, 2003 02:23 PM |