If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
general form question
Hi all, I got a really simple question, I have created a form from a table
using the form wizard, and all looks ok, but when i go into design view and try and move fields around the form they seem to be anchored on the spot, i can stretch them and shrink them but they will not move away from each other, any ideas ? Thanks |
#2
|
|||
|
|||
general form question
I will presume you are working with Access 2007 as I know this issue.
With the form in design view, select the Arrange tab on the top ribbon. Highlight all the controls that you want to split from the existing format and select "Remove" on the Control Layout of the Arrange Ribbon. All anchors to the controls should then be removed and you should be able to move them around at your pleasure. Hope this helps ????? -- Advice to Posters. Check your post for replies or request for more information. Consider providing some feed back to the response you have recieved. Kindest Regards Mike B "blake7" wrote: Hi all, I got a really simple question, I have created a form from a table using the form wizard, and all looks ok, but when i go into design view and try and move fields around the form they seem to be anchored on the spot, i can stretch them and shrink them but they will not move away from each other, any ideas ? Thanks |
#3
|
|||
|
|||
general form question
Thanks Mike, I knew there must be a simple solution, just started working
with Access 2007, still finding my way round. Thanks again "MikeJohnB" wrote: I will presume you are working with Access 2007 as I know this issue. With the form in design view, select the Arrange tab on the top ribbon. Highlight all the controls that you want to split from the existing format and select "Remove" on the Control Layout of the Arrange Ribbon. All anchors to the controls should then be removed and you should be able to move them around at your pleasure. Hope this helps ????? -- Advice to Posters. Check your post for replies or request for more information. Consider providing some feed back to the response you have recieved. Kindest Regards Mike B "blake7" wrote: Hi all, I got a really simple question, I have created a form from a table using the form wizard, and all looks ok, but when i go into design view and try and move fields around the form they seem to be anchored on the spot, i can stretch them and shrink them but they will not move away from each other, any ideas ? Thanks |
#4
|
|||
|
|||
general form question
We can't see what you're doing. Do you have "Snap to Grid" turned on?
HTH -- -Larry- -- "blake7" wrote in message ... Hi all, I got a really simple question, I have created a form from a table using the form wizard, and all looks ok, but when i go into design view and try and move fields around the form they seem to be anchored on the spot, i can stretch them and shrink them but they will not move away from each other, any ideas ? Thanks |
Thread Tools | |
Display Modes | |
|
|