|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 25th, 2004, 10:26 AM
|
|||
|
|||
Conditional page breaks
Hi
Is it possible to give conditional page breaks in access reports depending on a field value? Thanks Regards 
|
|
#2
May 25th, 2004, 02:59 PM
|
|||
|
|||
|
Conditional page breaks
John wrote:
Is it possible to give conditional page breaks in access reports depending on a field value? You can insert a PageBreak control in the report and then use code in the section's Format event to test the valus of the field and make the page break control visible or not as needed: Me.pgBreak.Visible = (Me.field 123) -- Marsh MVP [MS Access]
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
