If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Printing in Visio 2003
Hi.
In making a Basic Network Diagram (Metric) I dragged an Ethernet component onto the drawing board. When I print though all the connectors are joined to the center of the Ethernet component. Regardless if they are joined to another component or not. But if you look in print preview it doesn't show it. This is quite frustrating as it really does ruin the network diagram. I have tried this in various places and the result is the same. |
Thread Tools | |
Display Modes | |
|
|