If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
VCC/HCC
I was wondering how I can annotate vertical cross-connectors and vertical
cross-connectors using Visio using 2k3 or 2k10? |
#2
|
|||
|
|||
VCC/HCC
On Tue, 13 Apr 2010 19:49:01 -0700, darrel wrote:
I was wondering how I can annotate vertical cross-connectors and vertical cross-connectors using Visio using 2k3 or 2k10? Are you using a particular shape for your cross-connectors or are you referring to the area where standard connectors cross? -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|