|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 20th, 2008, 08:08 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
Y Axis
I am trying to create an average line using a line chart on an existing
chart. When I try to match the values from the Y Axis from my primary request I change the scale but the numbers all default to percentages or decimals based off the percentages. I can't get whole number to show up even when I use the general or number tab. Can anyone help? Thanks, Meejung 
|
|
#2
October 20th, 2008, 10:22 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
|
Y Axis
Hi,
It suggest that you have fractions/percentage/decimals in the source range if changing the format does not change the display. -- Thanks, Shane Devenshire "Meejung" wrote: I am trying to create an average line using a line chart on an existing chart. When I try to match the values from the Y Axis from my primary request I change the scale but the numbers all default to percentages or decimals based off the percentages. I can't get whole number to show up even when I use the general or number tab. Can anyone help? Thanks, Meejung
|
|
#3
October 21st, 2008, 04:00 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
|
Y Axis
Shane,
Thanks for the reply. I was actually using the wrong graph. I was using the one for the percentages. It worked right when I used the right graph. Thanks "ShaneDevenshire" wrote: Hi, It suggest that you have fractions/percentage/decimals in the source range if changing the format does not change the display. -- Thanks, Shane Devenshire "Meejung" wrote: I am trying to create an average line using a line chart on an existing chart. When I try to match the values from the Y Axis from my primary request I change the scale but the numbers all default to percentages or decimals based off the percentages. I can't get whole number to show up even when I use the general or number tab. Can anyone help? Thanks, Meejung
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
