If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Lengthen Swim Lanes
I find that I need more room in my diagram so I changed from letter to legal
size, but I cannot figure out how to lengthen the swim lanes to accomodate the new size. |
#2
|
|||
|
|||
Lengthen Swim Lanes
Hello Habelow,
Resize your page and then click on View / Drawing Explorer, navigate to the 'Horizontal Holder' shape in the treeview and select it, and then resize it in the drawing page using the standard handles. Hope that helps. Best regards John John Goldsmith (Visio MVP) www.visualSignals.typepad.co.uk www.visualSignals.co.uk "habelow1" wrote in message ... I find that I need more room in my diagram so I changed from letter to legal size, but I cannot figure out how to lengthen the swim lanes to accomodate the new size. |
#3
|
|||
|
|||
Lengthen Swim Lanes
On Fri, 10 Oct 2008 14:10:01 -0700, habelow1
wrote: I find that I need more room in my diagram so I changed from letter to legal size, but I cannot figure out how to lengthen the swim lanes to accomodate the new size. click on the header area of the swimlanes, the whole block will then be selected. You'll see a green blob at the lower or right end (depending on whether you have vertical or horizontal lanes). Grab that blob and move it. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
Thread Tools | |
Display Modes | |
|
|