|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 16th, 2008, 09:21 PM
posted to microsoft.public.visio.general
|
|||
|
|||
Showing columns on tables imported from ERwin
I am trying to import some old ERwin diagrams into Visio 2007. I am able to
import the data just fine, but when I add an imported table to the drawing it does not display the columns. Is there a setting that needs to be changed in order to get the columns to display? 
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
