|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 10th, 2008, 09:19 PM
posted to microsoft.public.visio.general
|
|||
|
|||
changing ruler orientation
visio 2003 pro on xp.
with a landscape diagram the horizontal zero starts in the top left and the vertical zero starts at the bottom left. any way to get both zeros to start at the top left? thanks. 
|
|
#2
October 10th, 2008, 09:30 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
changing ruler orientation
On Fri, 10 Oct 2008 13:19:11 -0700 (PDT), nlehrer
wrote: visio 2003 pro on xp. with a landscape diagram the horizontal zero starts in the top left and the vertical zero starts at the bottom left. any way to get both zeros to start at the top left? If you can cope with negative values on the Y axis menu Tools - Ruler & Grid and set the vertical ruler zero to the page height. -- Regards, Paul Herber, Sandrila Ltd. http://www.electronics-packages.sandrila.co.uk/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
