|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 20th, 2006, 12:17 PM
posted to microsoft.public.access.reports
|
|||
|
|||
problem with pagebreak
Hello,
we are setting a page break visibility to TRUE within a subreport, however no page break is being entered. any ideas on why this should happen . we are using Access 2k Thanks 
|
|
#2
March 20th, 2006, 04:32 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
problem with pagebreak
Hello.
"a" wrote: we are setting a page break visibility to TRUE within a subreport, however no page break is being entered. any ideas on why this should happen . we are using Access 2k I think you can't use a pagebrake in a subreport. Don't use pagebreaks at all in reports. Can't you use groupings in the main report instead of the subreport? If so, you could use the NewPage property of a section to control pagebreaks. -- Regards, Wolfgang
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Relationship Problem | JNariss | New Users | 4 | December 14th, 2005 08:46 PM |
| Strange problem with different networks. | Adam | General Discussion | 1 | March 13th, 2005 10:17 PM |
| Reinstalling OE... | KAR | Outlook Express | 24 | August 21st, 2004 06:52 PM |
| Productkey problem when installing office 2003 on network | Stefan Schreurs | Setup, Installing & Configuration | 1 | June 1st, 2004 11:16 PM |
| word error | mac | General Discussions | 1 | May 6th, 2004 08:14 AM |
Linear Mode
