If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Why do field codes skip to the next line, like a forced return?
sometimes I find when I add cross referecnes into a document that the field
code (i.e. the inserted referece) jumps to the next line. So you end uo with something like..... For info see Section 1 - Introduction to Wotsit on page 9. This is no good, but I can't figure out how to fix it. Can anyone help? Thanks, Andrew. |
#2
|
|||
|
|||
Why do field codes skip to the next line, like a forced return?
Fields, like cross-reference, do allow text wrapping to occur within them, so
it should not be a problem with the field itself, but probably the text that is being referenced. In you example, I would check that "Introduction to Wotsit" does not have nonbreaking space between the words. If you show the non-printing characters, if not already (use Ctrl+Shft+8 to display), do you see ΒΊ between the words? Nonbreaking Spaces are created by using Ctrl+Shft+Spacebar and also can be pasted in from elsewhere. You can replace these with normal (breaking) spaces with Find/Replace. Open Find/Replace, either press Ctrl+Shft+spacebar or click on More button, Special and select nonbreaking space, you will see ^s - this is the code for this item. In the replace with, press the spacebar. Find and replace at will. The cross reference field will need refreshing and the text should now wrap. Quick way to refresh, is to seelct the whole document (Ctrl+A) then press F9, this will refresh all fields, this includes the Table of Contents and all Xrefs. Hope this helps DeanH "Andrew in Sydney." wrote: sometimes I find when I add cross referecnes into a document that the field code (i.e. the inserted referece) jumps to the next line. So you end uo with something like..... For info see Section 1 - Introduction to Wotsit on page 9. This is no good, but I can't figure out how to fix it. Can anyone help? Thanks, Andrew. |
Thread Tools | |
Display Modes | |
|
|