|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 22nd, 2008, 04:04 PM
posted to microsoft.public.access.reports
|
|||
|
|||
gap in field
hi
Can you help please? I am designing a report which must be in the same format as a claim form designed by a customer .The problem is when I place a field or sub report a long side another field I get a gap in form which means it does not fit on page. Regards 
|
|
#2
September 22nd, 2008, 06:55 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
gap in field
If you are trying to match a paper form exactly, then DO NOT USE can grow or
can shrink on your controls and sections. John Spencer Access MVP 2002-2005, 2007-2008 The Hilltop Institute University of Maryland Baltimore County cjgav wrote: hi Can you help please? I am designing a report which must be in the same format as a claim form designed by a customer .The problem is when I place a field or sub report a long side another field I get a gap in form which means it does not fit on page. Regards
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
