If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Draw Vertical line in the report Detail section
I want to draw a Vertical Line in the Report details section at about 6 Inch.
I tried to do but it effects the Detail section record, I mean each Record line of detail section get the line repeated. If there is seven Record line in the detail section, it takes 7 times the 6 inch line and exapands into many pages. My need to draw a vertical line at the LHS side of the report of about 6 inch, the same in the RHS side. BUT it should not effect the detail section records. Please advise Thanks and best regards. Irshad |
#2
|
|||
|
|||
Draw Vertical line in the report Detail section
You can use code in the On Page event of the report. This code will draw
lines from the top of the page down 6" on both the left and right sides. Private Sub Report_Page() Me.Line (0, 0)-Step(0, 1440 * 6) Me.Line (Me.Width, 0)-Step(0, 1440 * 6) End Sub -- Duane Hookom Microsoft Access MVP "Irshad Alam" wrote: I want to draw a Vertical Line in the Report details section at about 6 Inch. I tried to do but it effects the Detail section record, I mean each Record line of detail section get the line repeated. If there is seven Record line in the detail section, it takes 7 times the 6 inch line and exapands into many pages. My need to draw a vertical line at the LHS side of the report of about 6 inch, the same in the RHS side. BUT it should not effect the detail section records. Please advise Thanks and best regards. Irshad |
Thread Tools | |
Display Modes | |
|
|