If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Snaking Columns Report
Hello,
I have a multiple-column report, the multiple-column list is in the sub report. The problem is, it will only print as many lines that fit in the sub report, the rest of the lines gets truncated and doesn't print at all. Is there a way to print the rest of the records on the second page? Thanks in advance Abe |
#2
|
|||
|
|||
Snaking Columns Report
On Thu, 17 Sep 2009 12:15:36 -0400, Abe Katz wrote:
Hello, I have a multiple-column report, the multiple-column list is in the sub report. The problem is, it will only print as many lines that fit in the sub report, the rest of the lines gets truncated and doesn't print at all. Is there a way to print the rest of the records on the second page? Thanks in advance Abe Multi-column sub-reports either have to have CanGrow set to No on the sub- report control within the main report or else must use Across, Then Down columns. If you want a growing sub-report you cannot use Down, Then Across columns. -- Rick Brandt, Microsoft Access MVP Email (as appropriate) to... RBrandt at Hunter dot com |
Thread Tools | |
Display Modes | |
|
|