A Microsoft Office (Excel, Word) forum. OfficeFrustration

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » OfficeFrustration forum » Microsoft Powerpoint, Publisher and Visio » Visio
Site Map Home Register Authors List Search Today's Posts Mark Forums Read  

Controlling connectors on cross-overs (intersections)



 
 
Thread Tools Display Modes
  #1  
Old May 11th, 2010, 04:46 PM posted to microsoft.public.visio.general
Mike McCarty
external usenet poster
 
Posts: 1
Default Controlling connectors on cross-overs (intersections)

When two connector lines intersect, one of them will have a break or won't
have a break depending on the behavior settings for those lines. How does
one make one line jump over the other line with a half circle (standard
pipeline nomenclature for cross-overs)? Also, is it possible to have regular
lines behave this was too, or only connector type lines?

Thanks, Mike
  #2  
Old May 11th, 2010, 06:40 PM posted to microsoft.public.visio.general
AlEdlund
external usenet poster
 
Posts: 468
Default Controlling connectors on cross-overs (intersections)

The ability to control the 'lines' is limited to connectors. To change how
the route go to page setup, select layout and routing and adjust line jumps.
al


"Mike McCarty" Mike wrote in message
...
When two connector lines intersect, one of them will have a break or won't
have a break depending on the behavior settings for those lines. How does
one make one line jump over the other line with a half circle (standard
pipeline nomenclature for cross-overs)? Also, is it possible to have
regular
lines behave this was too, or only connector type lines?

Thanks, Mike


  #3  
Old May 13th, 2010, 02:47 PM posted to microsoft.public.visio.general
Doug.S
external usenet poster
 
Posts: 40
Default Controlling connectors on cross-overs (intersections)

You can do so manually with regular lines by using a half circle jump
shape....locate it where you want it and then connect lines to it. Changes
may require manual adjustments but it does work well.

Doug.S

"AlEdlund" wrote in message
...
The ability to control the 'lines' is limited to connectors. To change how
the route go to page setup, select layout and routing and adjust line
jumps.
al


"Mike McCarty" Mike wrote in message
...
When two connector lines intersect, one of them will have a break or
won't
have a break depending on the behavior settings for those lines. How
does
one make one line jump over the other line with a half circle (standard
pipeline nomenclature for cross-overs)? Also, is it possible to have
regular
lines behave this was too, or only connector type lines?

Thanks, Mike




 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 09:26 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 OfficeFrustration.
The comments are property of their posters.