If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Connector Tool not showing in page
I'm using Visio 2007. I'm unable to view the connector tool. I tried to
connect two shapes but the lines are not showing up. I tried to copy the lines from another shape and it would show but I could not drag or place it to another location. It's just stuck where it pasted itself. I can't move the copied lines at all. I'm trying to figure out what might I have done to get this issue. It was working before. |
#2
|
|||
|
|||
Connector Tool not showing in page
On Thu, 6 May 2010 10:58:01 -0700, Che wrote:
I'm using Visio 2007. I'm unable to view the connector tool. I tried to connect two shapes but the lines are not showing up. I tried to copy the lines from another shape and it would show but I could not drag or place it to another location. It's just stuck where it pasted itself. I can't move the copied lines at all. I'm trying to figure out what might I have done to get this issue. It was working before. Possibly a layers problem. menu View - Layer Properties Check that the shapes are not on a locked/hidden layer. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
#3
|
|||
|
|||
Connector Tool not showing in page
The connector tool should be on the main toolbar right next to the text tool.
It can be toggled between Connector Tool and Connection Point Tool. If you are in the Connection Point Tool mode a blue X icon should be displayed on the toolbar. In addition at the very end of your pointer there should be an X. To ensure you can see connection points make sure connection points are set to view. On the toolbar select view, locate connection points and place a check next to it. Once you have all these settings in place you should be able to see a connection point of a shape if it has one. You should also be able to move the connection point by holding down the control key on your keyboard while selecting the connection point. This will allow you to move an existing point. To add a new connection hold down the control key and left mouse click after you have selected the object. -- James W. "Paul Herber" wrote: On Thu, 6 May 2010 10:58:01 -0700, Che wrote: I'm using Visio 2007. I'm unable to view the connector tool. I tried to connect two shapes but the lines are not showing up. I tried to copy the lines from another shape and it would show but I could not drag or place it to another location. It's just stuck where it pasted itself. I can't move the copied lines at all. I'm trying to figure out what might I have done to get this issue. It was working before. Possibly a layers problem. menu View - Layer Properties Check that the shapes are not on a locked/hidden layer. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ . |
Thread Tools | |
Display Modes | |
|
|