If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
#Error on report
I have created the following expression:
=[TOTAL EQUIPMENT]+[F5 EQUIPMENT] totaling 2 fields, but when I look at the report, I get the #Error message for the field. What am I doing wrong? Allan |
#2
|
|||
|
|||
On Wed, 25 Aug 2004 14:59:02 -0700, Allan Pratt wrote:
I have created the following expression: =[TOTAL EQUIPMENT]+[F5 EQUIPMENT] totaling 2 fields, but when I look at the report, I get the #Error message for the field. What am I doing wrong? Allan Make sure the name of the control on the report is not the same as one of the field names used in it's control source expression. -- Fred Please only reply to this newsgroup. I do not reply to personal email. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
programmatically add controls to report | G | Setting Up & Running Reports | 2 | August 4th, 2004 09:11 PM |
Restrict Report To Current Record | Katherine R | Setting Up & Running Reports | 1 | July 15th, 2004 07:23 PM |
Restrict Report to Current Record | Katherine R | Setting Up & Running Reports | 1 | July 15th, 2004 07:23 PM |
6 Tables, 1 Report, W/O 6 Qrys | Andy | Setting Up & Running Reports | 9 | June 29th, 2004 09:52 PM |
Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |