If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2-Sided Printing: HP Photosmart D7300 Series. Right edge of imageclipped off, won't allow manual feed
We are wasting tons of paper trying to print a "booklet" 2 sided.
Printer: HP Photosmart D7300 Paper 8.5x11 Booklet 5.5 x 8.5 Printer set at landscape Ran 2-side configuration wizard. Did all paper feeds (numbers and circles) When attempting to print, right side is clipped off No prompts appear to turn paper over. When printer is set to BORDERLESS, the full right side of image appears, but left side of page is trimmed off. "fit image to paper" option vanishes. Is there a way to do this? Thank you. |
#2
|
|||
|
|||
2-Sided Printing: HP Photosmart D7300 Series. Right edge of image clipped off, won't allow manual feed
How many pages? Is the print preview correct?
I only know how I print on my PhotoSmart. If I have an eight page booklet I type 1,6,3,8 for the first side, print, I restack the two sheets, I then type 7,4,5,2. This always works for me. My confusion with the printer is the default is to print the last page first. I always forget to change it. If you have more than 8 pages, you will have to alternate the stack when you print the second side. A 24 page booklet looks like this 1,22,5,18,9,14,11,16,7,20,3,24 2,21,6,17,10,13,12,15,8,19,4,23 This is the reason most of my booklets are printed on my laser, it has a duplex unit. I am hoping the service pack will simplify this. At least put it back to the 2003 way of printing. I have yet been able to print borderless in Publisher. -- Mary Sauer http://msauer.mvps.org/ "Puzzled Publisher" wrote in message ... We are wasting tons of paper trying to print a "booklet" 2 sided. Printer: HP Photosmart D7300 Paper 8.5x11 Booklet 5.5 x 8.5 Printer set at landscape Ran 2-side configuration wizard. Did all paper feeds (numbers and circles) When attempting to print, right side is clipped off No prompts appear to turn paper over. When printer is set to BORDERLESS, the full right side of image appears, but left side of page is trimmed off. "fit image to paper" option vanishes. Is there a way to do this? Thank you. |
Thread Tools | |
Display Modes | |
|
|