|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 9th, 2009, 06:39 PM
posted to microsoft.public.access.queries
|
|||
|
|||
Access queries for Access 2003
When I run a query, the display window shows only about 13 lines at a time
unless I manually stretch the window vertically. How do I set it to show a specific number of lines when the query window displays (the same way I can adjust the number of display lines in a combo box or a list box)? 
|
|
#2
June 9th, 2009, 06:48 PM
posted to microsoft.public.access.queries
|
|||
|
|||
|
Access queries for Access 2003
Create a form based on the query. Make the form's default view Datasheet. You
should be able to size and save the form. If you need greater control, you can use the Movesize function on the On Open event to precisely place and size the form. -- Jerry Whittle, Microsoft Access MVP Light. Strong. Cheap. Pick two. Keith Bontrager - Bicycle Builder. "Nightgems" wrote: When I run a query, the display window shows only about 13 lines at a time unless I manually stretch the window vertically. How do I set it to show a specific number of lines when the query window displays (the same way I can adjust the number of display lines in a combo box or a list box)?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
