|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 12th, 2010, 02:39 AM
posted to microsoft.public.access.reports
|
|||
|
|||
hide controls in the page footer on the last page of report
I have done as you suggest. still it is not working. i have placed the code
in the page footer section format event. -- from chanakya Baruva 
|
|
#2
April 12th, 2010, 05:04 AM
posted to microsoft.public.access.reports
|
|||
|
|||
|
hide controls in the page footer on the last page of report
Do you have a control in your page section that is bound to [Pages]?
What does happen? -- Duane Hookom Microsoft Access MVP "Access infant" wrote: I have done as you suggest. still it is not working. i have placed the code in the page footer section format event. -- from chanakya Baruva
|
|
#3
April 13th, 2010, 02:33 AM
posted to microsoft.public.access.reports
|
|||
|
|||
|
hide controls in the page footer on the last page of report
I would like to direct your attention to one of my earlier post where it is
recommended not to use a page control http://www.microsoft.com/communities...&cr=&sloc=&p=1 That's why i have not added any control. By the way, i have tried this also(after your post). but i cannot see any [ pages] in the controlsource. How can i bind it? please help -- from chanakya Baruva
|
|
#4
April 13th, 2010, 04:22 AM
posted to microsoft.public.access.reports
|
|||
|
|||
|
hide controls in the page footer on the last page of report
There was no recommendation to not use a page control. The suggestion was
that it wasn't necessary for the solution in that thread. Add a text box to the page header or footer section and set its Control Source to: =[Pages] -- Duane Hookom MS Access MVP "Access infant" wrote in message ... I would like to direct your attention to one of my earlier post where it is recommended not to use a page control http://www.microsoft.com/communities...&cr=&sloc=&p=1 That's why i have not added any control. By the way, i have tried this also(after your post). but i cannot see any [ pages] in the controlsource. How can i bind it? please help -- from chanakya Baruva
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
