If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Diagonal borders don't line up
I have used the diagonal border for the corners of my table (since you can't do a rounded border). But I can't figure out if there is a reason why the border is not seamless. It doesn't connect well to the vertical border on the cell above it, on the right side of the ascending diagonal, and sometimes not on the left side of the descending diagonal. It makes it look pretty unprofessional. Is there a way to correct that?
|
#2
|
|||
|
|||
Diagonal borders don't line up
G'Day "ShanKat"
I agree with your assessment only if you are describing the on-screen display. I find that it Prints correctly. -- Regards, Pat Garard Australia ______________________________________ |
#3
|
|||
|
|||
Diagonal borders don't line up
No... the on-screen display is even worse, but the print-out is a little off too. There are tiny gaps and/or lines sticking out.
"Pat Garard" wrote: G'Day "ShanKat" I agree with your assessment only if you are describing the on-screen display. I find that it Prints correctly. -- Regards, Pat Garard Australia ______________________________________ |
#4
|
|||
|
|||
Diagonal borders don't line up
G'Day again!
The only thing I can suggest is that you upgrade your printer driver. I wonder if anyone else has had a similar issue. -- Regards, Pat Garard Australia ______________________________________ |
#5
|
|||
|
|||
Diagonal borders don't line up
Hmm... interesting suggestion. I wonder. The issue carried over when I tried turning the document into a .pdf, and it also carried over to the proof I got back from the proffessional print shop I sent the Word document to. So I think it is most likely not the printer. Sounds like maybe a glitch?
"Pat Garard" wrote: G'Day again! The only thing I can suggest is that you upgrade your printer driver. I wonder if anyone else has had a similar issue. -- Regards, Pat Garard Australia ______________________________________ |
#6
|
|||
|
|||
Diagonal borders don't line up
Hi again!
I have tried producing a PDF, and it messes up completely!! But I got no answers. -- Regards, Pat Garard Australia ______________________________________ |
Thread Tools | |
Display Modes | |
|
|