If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
page break
After I insert a page break, there is always a blank page after. How can I
eliminate the blank page? I am using MS Access 97. Please help. Thanks. |
#2
|
|||
|
|||
00allen_iverson wrote:
After I insert a page break, there is always a blank page after. How can I eliminate the blank page? I am using MS Access 97. Please help. Thanks. Are you sure that the marging are correct? -- _ _ Ciao MAssimiliano Amendola www.accessgroup.it Cisa1 - I° Conferenza Italiana per Sviluppatori Access Arezzo 4+5 Giugno 2005 Sono aperte le iscrizioni Info: www.donkarl.com/it |
#3
|
|||
|
|||
This always happens when there is space after the page break object. Make
sure your bottom border of your section is up tight against the page break object (where you cannot see the object anymore). Hope this helps. "00allen_iverson" wrote: After I insert a page break, there is always a blank page after. How can I eliminate the blank page? I am using MS Access 97. Please help. Thanks. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Retaining Section Break at the Bottom of Page 1 | Diane M | Formatting Long Documents | 3 | January 14th, 2005 09:16 PM |
Page Break! | Bec_FS | Using Forms | 6 | December 7th, 2004 07:39 PM |
Extra detail format | Phil | Setting Up & Running Reports | 8 | November 10th, 2004 01:13 AM |
Changing Page Numbers | Wood | General Discussion | 1 | August 14th, 2004 05:54 AM |
Page Break Problems | Tim | Setting Up & Running Reports | 1 | June 29th, 2004 06:41 PM |