If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Problems with columns, macros and auto filter
I have a spreadheet in which I would like to insert a
column. Since the auto filter is activated and there is macros using the autofilter command, I have to de-activate the autofilter and then insert the collumn. The problems is this: After I have inserted the column and want to activate the auto filter once again, it does not want to locate to the original position (row) and thus negatively affects the macros. Can anyone supply a solution? Regards |
#2
|
|||
|
|||
Problems with columns, macros and auto filter
as usual, you should post your code for comments.
-- Don Guillett SalesAid Software "Johan Swanepoel" wrote in message ... I have a spreadheet in which I would like to insert a column. Since the auto filter is activated and there is macros using the autofilter command, I have to de-activate the autofilter and then insert the collumn. The problems is this: After I have inserted the column and want to activate the auto filter once again, it does not want to locate to the original position (row) and thus negatively affects the macros. Can anyone supply a solution? Regards |
#3
|
|||
|
|||
Problems with columns, macros and auto filter
Hi
you may post the relevant part of your current/existing macro. It should be no problem to store the current position and re-activate this again -----Original Message----- I have a spreadheet in which I would like to insert a column. Since the auto filter is activated and there is macros using the autofilter command, I have to de- activate the autofilter and then insert the collumn. The problems is this: After I have inserted the column and want to activate the auto filter once again, it does not want to locate to the original position (row) and thus negatively affects the macros. Can anyone supply a solution? Regards . |
Thread Tools | |
Display Modes | |
|
|