If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Breaking text and allowing it to continue at the top of the next p
I have a complicated report which has a grouping option where a heading,
subheading and text item will print together. If they can't fit at the bottom of the page, the whole group is printed on the following page. Problem is, sometimes the text item is really long and it could have printed partially on the bottom of the previous page if it were possible to allow it to continue to the next page. How is it possible to examine the length of the text parts concerned, to examine the amount of page left to print on, and to force the group to start at the bottom of the "previous" page instead of banging the whole text block as described above, on to a new page? I would appreciate any help. Thanks very much. |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Quotation marks (") in tab delimeted file causes loss of forma | Ross | Mailmerge | 3 | April 23rd, 2005 10:56 AM |
center text vertically inside text boxes | keaven | Setting Up & Running Reports | 3 | March 9th, 2005 07:08 PM |
Prevent Blank Records being written. Need Help. | Robert Nusz @ DPS | Using Forms | 4 | December 29th, 2004 05:15 PM |
Text Recovery and Open & Repair in WD 2003? | UserRAW1975 | General Discussion | 1 | December 22nd, 2004 03:00 AM |
Two versions again-language issue | Otto | Setup, Installing & Configuration | 3 | May 28th, 2004 04:57 AM |