|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 4th, 2005, 10:35 PM
|
|||
|
|||
Open report at 75% Zoom
Hi All,
I have a report which when opened shows full page. I have to zoom to 75% to view detail. How can I get the report to automatically open at 75% zoom? Thanks in advance, Jeff 
|
|
#2
October 4th, 2005, 11:18 PM
|
|||
|
|||
|
Jeff wrote:
I have a report which when opened shows full page. I have to zoom to 75% to view detail. How can I get the report to automatically open at 75% zoom? Add a line of code right after the OpenReport method line: DoCmd.RunCommand acCmdZoom75 -- Marsh MVP [MS Access]
|
|
#3
October 6th, 2005, 01:43 AM
|
|||
|
|||
|
Marshall Barton wrote:
Jeff wrote: I have a report which when opened shows full page. I have to zoom to 75% to view detail. How can I get the report to automatically open at 75% zoom? Add a line of code right after the OpenReport method line: DoCmd.RunCommand acCmdZoom75 Thanks, but I get a message 'Zoom 75% not available right now'or something like that - I'm using a Portuguese version. Any ideas? Jeff
|
|
#4
October 6th, 2005, 05:36 AM
|
|||
|
|||
|
Jeff wrote:
Marshall Barton wrote: Jeff wrote: I have a report which when opened shows full page. I have to zoom to 75% to view detail. How can I get the report to automatically open at 75% zoom? Add a line of code right after the OpenReport method line: DoCmd.RunCommand acCmdZoom75 Thanks, but I get a message 'Zoom 75% not available right now'or something like that - I'm using a Portuguese version. If it's a language issue, I can't provide any assistance beyond trying to find it in Help - VBE - Index - RunCommand -- Marsh MVP [MS Access]
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Access97: Report will not open | Jonathan Scott via AccessMonster.com | Setting Up & Running Reports | 2 | April 19th, 2005 01:26 AM |
| Making a report open in front of all other open forms | cindyn | Setting Up & Running Reports | 7 | January 30th, 2005 06:51 AM |
| using a form parameters to open a report | jkendrick75 | Setting Up & Running Reports | 5 | January 14th, 2005 05:05 PM |
| Open and filter a report from a control value on a data access pag | Mona-ABE | Setting Up & Running Reports | 0 | November 5th, 2004 01:45 PM |
| Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
Linear Mode
