If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Error 2004 not enough memory
Hi all,
Ive developed a small project in Microsoft Access 2007, however now i need to make it a Microsoft access 2003 project, since our customers are currently using that. Just saved the project as compatible with Microsoft Access 2003. except for minor adjustments such as the onclick event disappeared, everything worked ok. Now however I get Runtime Error 2004 not enough memory ..... Any ideas what might cause this problem? I have enough memory on the computer and so on... Would by grateful for any assistance in this matter... |
#2
|
|||
|
|||
Error 2004 not enough memory
what event is triggering this error?
-- NTC "Ingman" wrote: Hi all, Ive developed a small project in Microsoft Access 2007, however now i need to make it a Microsoft access 2003 project, since our customers are currently using that. Just saved the project as compatible with Microsoft Access 2003. except for minor adjustments such as the onclick event disappeared, everything worked ok. Now however I get Runtime Error 2004 not enough memory .... Any ideas what might cause this problem? I have enough memory on the computer and so on... Would by grateful for any assistance in this matter... |
#3
|
|||
|
|||
Error 2004 not enough memory
Hi again,
Sorry for the late response. This problem continue to show up from time to time, the event that triggers the error is when the form is opened i.e DoCmd.OpenForm "AName". Would appreciate any feedback in this matter "NetworkTrade" wrote: what event is triggering this error? -- NTC "Ingman" wrote: Hi all, Ive developed a small project in Microsoft Access 2007, however now i need to make it a Microsoft access 2003 project, since our customers are currently using that. Just saved the project as compatible with Microsoft Access 2003. except for minor adjustments such as the onclick event disappeared, everything worked ok. Now however I get Runtime Error 2004 not enough memory .... Any ideas what might cause this problem? I have enough memory on the computer and so on... Would by grateful for any assistance in this matter... |
#4
|
|||
|
|||
Error 2004 not enough memory
My experience with this error has been flaky hardware. Literally - reboot - and it worked fine.... happened a couple times with one particular PC only. Check to see if this might be your case - - in the end I was able to ignore it and blame it on the PC....if this is not your situation and it is occuring routinely on multiple PCs - then you should best start a new fresh post so you can get the attention of the current MVP monitors. "Ingman" wrote: Hi again, Sorry for the late response. This problem continue to show up from time to time, the event that triggers the error is when the form is opened i.e DoCmd.OpenForm "AName". Would appreciate any feedback in this matter "NetworkTrade" wrote: what event is triggering this error? -- NTC "Ingman" wrote: Hi all, Ive developed a small project in Microsoft Access 2007, however now i need to make it a Microsoft access 2003 project, since our customers are currently using that. Just saved the project as compatible with Microsoft Access 2003. except for minor adjustments such as the onclick event disappeared, everything worked ok. Now however I get Runtime Error 2004 not enough memory .... Any ideas what might cause this problem? I have enough memory on the computer and so on... Would by grateful for any assistance in this matter... |
Thread Tools | |
Display Modes | |
|
|