If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
multiple selection in report
I have a report that prints from a multiple selection. For example, field
could equal any combination of Airframe, LH Engine, RH Engine, etc, and I want the report to seperate them, Airframe report, LH Engine report, etc. At the moment I get a report that prints the data for every combination. |
#2
|
|||
|
|||
multiple selection in report
Rachel Ruta wrote:
I have a report that prints from a multiple selection. For example, field could equal any combination of Airframe, LH Engine, RH Engine, etc, and I want the report to seperate them, Airframe report, LH Engine report, etc. At the moment I get a report that prints the data for every combination. You mean you're trying to filter your report based on selections in a multi- select listbox? http://www.mvps.org/access/reports/rpt0005.htm You would just open the filtered report, print it out, close the report, then open again with a new filter (the next one in the list). -- Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...ports/201004/1 |
#3
|
|||
|
|||
multiple selection in report
Thanks Pieter, this worked, however I wanted the report to print all of the
selection in one task, e.g. Report for Airframe, LH Engine, RH Engine, etc. "PieterLinden via AccessMonster.com" wrote: Rachel Ruta wrote: I have a report that prints from a multiple selection. For example, field could equal any combination of Airframe, LH Engine, RH Engine, etc, and I want the report to seperate them, Airframe report, LH Engine report, etc. At the moment I get a report that prints the data for every combination. You mean you're trying to filter your report based on selections in a multi- select listbox? http://www.mvps.org/access/reports/rpt0005.htm You would just open the filtered report, print it out, close the report, then open again with a new filter (the next one in the list). -- Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...ports/201004/1 . |
Thread Tools | |
Display Modes | |
|
|