|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 23rd, 2005, 08:42 PM
posted to microsoft.public.access.reports
|
|||
|
|||
Newspaper columns in a report
I used page setup to put multiple columns on a single page. However the
columns do not come out even. Can I set it so that the columns are specfic to a section? -- Debra H 
|
|
#2
November 23rd, 2005, 10:21 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
Newspaper columns in a report
DebraH wrote:
I used page setup to put multiple columns on a single page. However the columns do not come out even. Can I set it so that the columns are specfic to a section? All of the output columns likely are all in one section. Did you try using "Across, Then Down" instead of "Down, Then Across" for the column settings? That will give you better uniformity on the column heights. -- I don't check the Email account attached to this message. Send instead to... RBrandt at Hunter dot com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Printing Reports Access 2002 Pleas Advise | Dermot | Database Design | 12 | October 5th, 2005 11:23 AM |
| all columns not always present in query - report won't run | Ellen | Running & Setting Up Queries | 3 | September 22nd, 2005 06:20 AM |
| Has anyone seen this behaviour? What might it be? | tw | General Discussion | 4 | June 30th, 2005 03:23 PM |
| To Sharkbyte and all: Calculate a total values in group level | Ally | General Discussion | 6 | June 13th, 2005 08:16 PM |
| Help!! I'm running around in circles! | CathyA | New Users | 19 | December 12th, 2004 07:50 PM |
Linear Mode
