If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
tab inside label
I've used tab inside a label in order to create a 'column effect'. Well it works but it adds too much 'tab' space. Is it possible to configure it? Thanks in advance Agostino |
#2
|
|||
|
|||
tab inside label
Finally a question I think I can answer. Sorry for the others, but I tried.
When you edit the label, there is a ruler above it with litle triangles. Drag some or click on the ruler. Just as in Word. "Agostino" wrote: I've used tab inside a label in order to create a 'column effect'. Well it works but it adds too much 'tab' space. Is it possible to configure it? Thanks in advance Agostino |
#3
|
|||
|
|||
tab inside label
The text ruler is turned off by default in Visio, but you can turn it on by
right-clicking while in text edit mode (F2). Also you can add, remove and change tabs in the Format Text dialog. -- Mark Nelson Office Graphics - Visio Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Philippe C." wrote in message ... Finally a question I think I can answer. Sorry for the others, but I tried. When you edit the label, there is a ruler above it with litle triangles. Drag some or click on the ruler. Just as in Word. "Agostino" wrote: I've used tab inside a label in order to create a 'column effect'. Well it works but it adds too much 'tab' space. Is it possible to configure it? Thanks in advance Agostino |
Thread Tools | |
Display Modes | |
|
|