If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Line jumps on curved connectors?
I've been struggling with getting line connectore to work. I just realized
that they don't seem to work with curved connectors. If I change back to a right angle connector and move the connector slightly the line jumps show up. But never for curved connectore, even if the PAge Setup--LAyout and RTouting --? appearance is set to curved. Any clues? |
#2
|
|||
|
|||
Line jumps on curved connectors?
On Mon, 22 Feb 2010 11:43:03 -0800, agbvisio wrote:
I've been struggling with getting line connectore to work. I just realized that they don't seem to work with curved connectors. If I change back to a right angle connector and move the connector slightly the line jumps show up. But never for curved connectore, even if the PAge Setup--LAyout and RTouting --? appearance is set to curved. You are right, line jumps don't work on curved connectors. I don't think there is any way round this. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|