If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
network diagram
Is there some mechanism to expose in a label the ip address that has been set in the custom properties? Thanks in advance Agostino |
#2
|
|||
|
|||
network diagram
Have you tried the three Custom Callouts at the bottom of the Visio Extras /
Callouts stencil? "Agostino" wrote in message ... Is there some mechanism to expose in a label the ip address that has been set in the custom properties? Thanks in advance Agostino |
#3
|
|||
|
|||
network diagram
Ok. It works, but I want to save a sort of pre-configured custom callout.
Saving the form in a new stancil it saves also the actual data in my callout :-(. Is there a 'cleaner' way? Thanks again "David Parker" ha scritto nel messaggio ... Have you tried the three Custom Callouts at the bottom of the Visio Extras / Callouts stencil? "Agostino" wrote in message ... Is there some mechanism to expose in a label the ip address that has been set in the custom properties? Thanks in advance Agostino |
Thread Tools | |
Display Modes | |
|
|