|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 15th, 2004, 07:42 PM
|
|||
|
|||
Publisher 2000 Defaults
How can I change the margins from inches to centimetres as the default when starting the program?
|
|
#2
June 15th, 2004, 08:21 PM
|
|||
|
|||
|
Publisher 2000 Defaults
Tools, options, general tab, measurement units...
-- Mary Sauer MS MVP http://office.microsoft.com/ http://www.mvps.org/msauer/ news://msnews.microsoft.com "Richardmac" wrote in message ... How can I change the margins from inches to centimetres as the default when starting the program?
|
|
#3
June 16th, 2004, 04:47 AM
|
|||
|
|||
|
Publisher 2000 Defaults
"Mary Sauer" wrote in message ... Tools, options, general tab, measurement units... -- How can I change the margins from inches to centimetres as the default when starting the program? I do not believe the above solution always works. When you use a new template the default units starts out the same as the template was saved in USA by Microsoft. If you then change the defaults to metric and save the document it should remain that way. -- John G Wot's Your Real Problem?
|
|
#4
June 16th, 2004, 09:18 AM
|
|||
|
|||
|
Publisher 2000 Defaults
Go to the control panel, Regional and Language Options folder, change it to your
specifications. -- Mary Sauer MS MVP http://office.microsoft.com/ http://www.mvps.org/msauer/ news://msnews.microsoft.com "John G" wrote in message news  "Mary Sauer" wrote in message ... Tools, options, general tab, measurement units... -- How can I change the margins from inches to centimetres as the default when starting the program? I do not believe the above solution always works. When you use a new template the default units starts out the same as the template was saved in USA by Microsoft. If you then change the defaults to metric and save the document it should remain that way. -- John G Wot's Your Real Problem?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
