If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dragged 2 columns closer together, now can't see columns in betwee
Please help! I wanted to look at column "C" and column "F" right next to each other, so I dragged the edge of column "F" over to the edge of column "C". But now I can't seem to undo this drag so I can see columns "D" and "E" again. When I search for "D1" or "E1" via the go to command, a tiny part of the border between "C" and "F" is highlighted, so it doesn't seem like those two columns have been deleted. Does anyone know how to uncover those two columns? Thank you so much! |
#2
|
|||
|
|||
Dragged 2 columns closer together, now can't see columns in betwee
Select cell C1. Press Ctrl+Spacebar to select the entire column. Extend your
selection to F. by using right arrow... Increase the column width by dragging on the column header C OR From menu change the column width.. If this post helps click Yes --------------- Jacob Skaria "Carebeatle" wrote: Please help! I wanted to look at column "C" and column "F" right next to each other, so I dragged the edge of column "F" over to the edge of column "C". But now I can't seem to undo this drag so I can see columns "D" and "E" again. When I search for "D1" or "E1" via the go to command, a tiny part of the border between "C" and "F" is highlighted, so it doesn't seem like those two columns have been deleted. Does anyone know how to uncover those two columns? Thank you so much! |
#3
|
|||
|
|||
Dragged 2 columns closer together, now can't see columns in betwee
Highlight columns from C to F, and try Format/ Column/ Unhide.
If that doesn't work, try Format/ Column/ Width, and set to an appropriate value. (Default may be 8.43). -- David Biddulph Carebeatle wrote: Please help! I wanted to look at column "C" and column "F" right next to each other, so I dragged the edge of column "F" over to the edge of column "C". But now I can't seem to undo this drag so I can see columns "D" and "E" again. When I search for "D1" or "E1" via the go to command, a tiny part of the border between "C" and "F" is highlighted, so it doesn't seem like those two columns have been deleted. Does anyone know how to uncover those two columns? Thank you so much! |
Thread Tools | |
Display Modes | |
|
|