|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 30th, 2004, 02:45 PM
|
|||
|
|||
bubble charts (again)
When using a bubble chart, I've been using 'width' as the
thrid value, rather then area, via the 'Size represents' frame. Is there any way, however, to make the units in which you've specified the bubble width the same as the units on the axes? At the moment, bubbles within a chart are the right size in relation to each other, but bubbles on different charts are not. 
|
|
#2
October 1st, 2004, 03:59 AM
|
|||
|
|||
|
Josie -
This would be rather a difficult, albeit tedious, task. You would have to first make sure the axis sizes and scales of the multiple charts all matched up. - Jon ------- Jon Peltier, Microsoft Excel MVP Peltier Technical Services Tutorials and Custom Solutions http://PeltierTech.com/ _______ Josie wrote: When using a bubble chart, I've been using 'width' as the thrid value, rather then area, via the 'Size represents' frame. Is there any way, however, to make the units in which you've specified the bubble width the same as the units on the axes? At the moment, bubbles within a chart are the right size in relation to each other, but bubbles on different charts are not.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bubble charts | josie | Charts and Charting | 3 | September 28th, 2004 08:21 PM |
| Bubble Charts | Patrick_KC | General Discussion | 1 | August 4th, 2004 07:38 PM |
| Creating Bubble Charts | tina | Charts and Charting | 1 | February 6th, 2004 12:02 PM |
| Bubble Charts Overlap | Tan | Charts and Charting | 3 | January 6th, 2004 01:50 PM |
Linear Mode
