If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
vertical scale on both ends of bar chart
How can I put the vertical (y) axis scale on both ends of a bar chart? I
tried putting one of the series on the secondary axis, but that just plots the secondary axis series on top of the primary axis data and in the center of the chart. Using Select Data Source the secondary axis series would not move either up or down. |
#2
|
|||
|
|||
vertical scale on both ends of bar chart
When you make a column chart the y-axis is generally to the left of the plot
area. If you add a seconday axis it noramlly goes to the right of the plot area. It sounds as if you have adjusted the axis to be somewhere else. Try making a new chart best wishes -- www.stfx.ca/people/bliengme "Midjack" wrote: How can I put the vertical (y) axis scale on both ends of a bar chart? I tried putting one of the series on the secondary axis, but that just plots the secondary axis series on top of the primary axis data and in the center of the chart. Using Select Data Source the secondary axis series would not move either up or down. |
Thread Tools | |
Display Modes | |
|
|