|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 6th, 2008, 05:47 PM
posted to microsoft.public.access.forms
|
|||
|
|||
Error message when trying to open a 2nd from based on same table
I have a form opened and I want to open a second form (while the first form
remains open) that is based on the same table. When trying to open the second form, I get an error message that says: The table 'Patients' is already opened exclusively by another user, or it is open through the user interface and cannot be manipulated programmatically. I can't figure out what setting I set incorrectly. Does anyone know how to correct this problem? 
|
|
#2
April 7th, 2008, 03:46 AM
posted to microsoft.public.access.forms
|
|||
|
|||
|
Error message when trying to open a 2nd from based on same table
Why would you need to have a 2nd form based on the same table? It doesn't
make sense and it really isn't good to do. If you provide your reasoning as to what you are actually trying to accomplish, we might have a better suggestion. -- Bob Larson Access World Forums Super Moderator Utter Access VIP Tutorials at http://www.btabdevelopment.com __________________________________ "magicdds" wrote: I have a form opened and I want to open a second form (while the first form remains open) that is based on the same table. When trying to open the second form, I get an error message that says: The table 'Patients' is already opened exclusively by another user, or it is open through the user interface and cannot be manipulated programmatically. I can't figure out what setting I set incorrectly. Does anyone know how to correct this problem?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
