|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
September 13th, 2005, 06:10 PM
|
|||
|
|||
RTimberlake wrote:
How many tables can you put on a query? I can do some of the tables as subforms, but I will still have 4 tables that cannot be done as subforms. Read the help topic "When can I update data in a query" as there is not a cut and dried answer to this. Every query is different, but basically as soon as the structure of the query makes it difficult for Access to know where (which table) the edits should go, then the query reverts to read-only. Sometimes the query design can be tweaked to make it editable again, sometimes not. -- I don't check the Email account attached to this message. Send instead to... RBrandt at Hunter dot com 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Big number gives error! | Sara Mellen | Running & Setting Up Queries | 8 | October 11th, 2004 02:48 AM |
| Taher | Setting Up & Running Reports | 1 | August 31st, 2004 09:07 PM | |
| Opening a Form which is based on a query from other forms | Larnoc | New Users | 1 | August 11th, 2004 01:20 PM |
| Master Form based on Query - Help! | Ben Johnson | Running & Setting Up Queries | 1 | August 6th, 2004 02:06 PM |
| Report Based Upon Parameter Query with Form References | Vincent DeLuca | Setting Up & Running Reports | 4 | July 19th, 2004 01:55 AM |
Linear Mode
