If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Open Access 2007 in Exclusive Mode
I have a mulit-user program. How can I set it up to allow one user access at
a time. |
#2
|
|||
|
|||
Open Access 2007 in Exclusive Mode
On Thu, 27 May 2010 14:05:51 -0700, iholder
wrote: In the shortcut to start the program, add the /excl command line switch. Another approach would be to check if the back-end has a .ldb file. If it does someone else is already in (or a rare crash occurred). -Tom. Microsoft Access MVP I have a mulit-user program. How can I set it up to allow one user access at a time. |
Thread Tools | |
Display Modes | |
|
|