If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sorry, basic forms question
I've searched back through the posts for an answer, but can't come up with
anything. How can I open a form and automatically put it into 'Create New Record' mode without setting it as a 'data entry' form ? I know it's going to be something obvious that I've missed, so please be gentle with me :-) Thanks Mike |
#2
|
|||
|
|||
Sorry, basic forms question
in the form's On Load event procedu
DoCmd.GoToRecord , , acNewRec HTH, Brian "Mike Morton" michael.mortonAT_nospam_lawtonsDOTcoDOTuk wrote in message ... I've searched back through the posts for an answer, but can't come up with anything. How can I open a form and automatically put it into 'Create New Record' mode without setting it as a 'data entry' form ? I know it's going to be something obvious that I've missed, so please be gentle with me :-) Thanks Mike |
#3
|
|||
|
|||
Sorry, basic forms question
Put the following in the form's open event:
DoCmd.GoToRecord,,acNewRec -- Rick B "Mike Morton" michael.mortonAT_nospam_lawtonsDOTcoDOTuk wrote in message ... I've searched back through the posts for an answer, but can't come up with anything. How can I open a form and automatically put it into 'Create New Record' mode without setting it as a 'data entry' form ? I know it's going to be something obvious that I've missed, so please be gentle with me :-) Thanks Mike |
#4
|
|||
|
|||
Sorry, basic forms question
Ahhh yes, I *knew* it was going to be something obvious that I'd missed.
Thanks very much for that gents. Mike "Mike Morton" michael.mortonAT_nospam_lawtonsDOTcoDOTuk wrote in message ... I've searched back through the posts for an answer, but can't come up with anything. How can I open a form and automatically put it into 'Create New Record' mode without setting it as a 'data entry' form ? I know it's going to be something obvious that I've missed, so please be gentle with me :-) Thanks Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question on checkboxes/protected forms and fill-in fields | Tracey | General Discussion | 4 | February 10th, 2006 10:04 PM |
Visual Basic question: end of Page | markvi | General Discussion | 6 | February 2nd, 2006 10:35 PM |
Expanding/Contracting forms (newbie question) | Maury Markowitz | General Discussion | 2 | December 21st, 2005 05:24 PM |
Basic INDEX(MATCH()) Question: | Adam Kroger | General Discussion | 6 | December 17th, 2005 04:30 AM |
Easy Question About Forms | wessleym | General Discussion | 5 | June 21st, 2004 06:41 AM |