If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Resizing Walls
The built in room shapes, "T" or "L", have walls that stay connected when one
wall is rezised. I have a more complex layout of exterior walls for my plant that I would like to layout in Visio. However, after I get them laid out using the exterior wall shapes, simply trying to resize one wall will disconnect it from the previously adjoining walls. Can I connect these walls so that as I drag a wall, the perpendicualr adjoining walls resize automatically, like they do in the "L" room or "T" room shapes? |
Thread Tools | |
Display Modes | |
|
|