If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access 2003 won't list the objects of a specific database in desig
I have an Access 2003 DB that I have been developing that executes normally.
When I enter design mode Access will not display objects (Tables, queries, forms,etc.). I just get a a basic tool bar and a blank screen. Running compact and repair has no effect on correcting this abnormality. I can open tools and view relationships. All other db's behave normally in design mode. I have backups so I can restore it. I need to find if I'm inadvertantly cause this. Thanks, Hunter |
#2
|
|||
|
|||
Access 2003 won't list the objects of a specific database in desig
My appologies to everyone - please ignore the original post. I just fat
fingered the keyboard and messed up the display tiling. Oops! "WylieCoyote" wrote: I have an Access 2003 DB that I have been developing that executes normally. When I enter design mode Access will not display objects (Tables, queries, forms,etc.). I just get a a basic tool bar and a blank screen. Running compact and repair has no effect on correcting this abnormality. I can open tools and view relationships. All other db's behave normally in design mode. I have backups so I can restore it. I need to find if I'm inadvertantly cause this. Thanks, Hunter |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Toolbars, Drop-Down Menus | Rick | New Users | 1 | September 21st, 2005 11:17 AM |
Table Design | A. Williams | Database Design | 3 | April 29th, 2005 07:02 PM |
Access 2000 -vs- Access 2003? | Mark | General Discussion | 5 | November 30th, 2004 06:36 AM |
Why can't I view VBA References | TracyG | General Discussion | 4 | November 24th, 2004 04:53 PM |
Using an access 2000 database in access 2003 | Rob R | General Discussion | 0 | October 7th, 2004 04:19 PM |