If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Connector Tool not showing in page
I'm using Visio 2007. I'm unable to view the connector tool. I tried to
connect two shapes but the lines are not showing up. I tried to copy the lines from another shape and it would show but I could not drag or place it to another location. It's just stuck where it pasted itself. I can't move the copied lines at all. I'm trying to figure out what might I have done to get this issue. It was working before. |
Thread Tools | |
Display Modes | |
|
|