If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2 superimposed dashed lines become solid
When 2 or more Connector lines with a dashed pattern are partially
superimposed, this may make part of the combined line look solid. Is it possible for Visio to show the pattern of the front order line only, so that the pattern is always consistant? |
#2
|
|||
|
|||
2 superimposed dashed lines become solid
I did it with the operation "trim", but that is probably now what you want.
"GtR" wrote: When 2 or more Connector lines with a dashed pattern are partially superimposed, this may make part of the combined line look solid. Is it possible for Visio to show the pattern of the front order line only, so that the pattern is always consistant? |
Thread Tools | |
Display Modes | |
|
|