If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"&" as text on a Label
How do you use the & character as text in a label on a form. It shows up in the Design View, but is not visible on the Form View.
|
#2
|
|||
|
|||
"&" as text on a Label
Use two '&' together eg && will show as & on the form when run.
"Moonman" wrote in message ... How do you use the & character as text in a label on a form. It shows up in the Design View, but is not visible on the Form View. |
#3
|
|||
|
|||
"&" as text on a Label
On Mon, 21 Jun 2004 09:09:02 -0700, Moonman wrote:
How do you use the & character as text in a label on a form. It shows up in the Design View, but is not visible on the Form View. Double it up. Text && More Text -- Fred Please only reply to this newsgroup. I do not reply to personal email. |
#4
|
|||
|
|||
"&" as text on a Label
using && in design view will display a single & in form view.
-- George Nicholson Remove 'Junk' from return address. "Moonman" wrote in message ... How do you use the & character as text in a label on a form. It shows up in the Design View, but is not visible on the Form View. |
Thread Tools | |
Display Modes | |
|
|