If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Close a shape
Hi, when I draw a shape sometimes I don't close it because I can't see vertex
or initial point , so I can't fill it. In order to apply fill I zoom to max and see all point to detect the breake, please how I can fix it?, or how I can close a shape automatically? (not Joint command). Thanks. Julian Q |
#2
|
|||
|
|||
Close a shape
On Fri, 3 Oct 2008 09:01:02 -0700, Julian Q
wrote: Hi, when I draw a shape sometimes I don't close it because I can't see vertex or initial point , so I can't fill it. In order to apply fill I zoom to max and see all point to detect the breake, please how I can fix it?, or how I can close a shape automatically? (not Joint command). Thanks. You could go into the shape's shapesheet and edit the geometry and set the final X and Y to be Geometry1.X1 and Y1 -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/ |
#3
|
|||
|
|||
Close a shape
"Paul Herber" wrote in message
ell.net... On Fri, 3 Oct 2008 09:01:02 -0700, Julian Q wrote: Hi, when I draw a shape sometimes I don't close it because I can't see vertex or initial point , so I can't fill it. In order to apply fill I zoom to max and see all point to detect the breake, please how I can fix it?, or how I can close a shape automatically? (not Joint command). Thanks. You could go into the shape's shapesheet and edit the geometry and set the final X and Y to be Geometry1.X1 and Y1 -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/ Another thing to check is if you are dealing with a single shape. Select around the shape and verify that only one item is selected. You can then use JOIN to combine. Also, it may be a single shape, but contain multiple Geometry sections for a shape to close, all the lie segments need to be in the same Geometry section. John... Visio MVP |
#4
|
|||
|
|||
Close a shape
Paul and John, thank you so much for your help, my problem is solved. I
applied Paul's recommendations, it was ok. John thanks for your suggestions!! "John... Visio MVP" wrote: "Paul Herber" wrote in message ell.net... On Fri, 3 Oct 2008 09:01:02 -0700, Julian Q wrote: Hi, when I draw a shape sometimes I don't close it because I can't see vertex or initial point , so I can't fill it. In order to apply fill I zoom to max and see all point to detect the breake, please how I can fix it?, or how I can close a shape automatically? (not Joint command). Thanks. You could go into the shape's shapesheet and edit the geometry and set the final X and Y to be Geometry1.X1 and Y1 -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/ Another thing to check is if you are dealing with a single shape. Select around the shape and verify that only one item is selected. You can then use JOIN to combine. Also, it may be a single shape, but contain multiple Geometry sections for a shape to close, all the lie segments need to be in the same Geometry section. John... Visio MVP |
Thread Tools | |
Display Modes | |
|
|