|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 3rd, 2008, 05:21 AM
posted to microsoft.public.visio.general
|
|||
|
|||
Change Box Shape
Hi,
I need to change a box shape but am not sure how. What I am after is something like the "rounded rectangle" shape but I want it to look something like a fat "L". Say for instance if I have a rectangle and then drag one corner diagonally in. I am using Viso 2007. Thanks. 
|
|
#2
October 3rd, 2008, 11:26 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Change Box Shape
On Thu, 2 Oct 2008 21:21:00 -0700, Roden
wrote: Hi, I need to change a box shape but am not sure how. What I am after is something like the "rounded rectangle" shape but I want it to look something like a fat "L". Say for instance if I have a rectangle and then drag one corner diagonally in. Open the Cubicles stencil (menu File - Shapes - Maps and Floor plans) and use the Corner surface shape. It has two yellow handles that can be dragged to change the form of the shape, drag the lower one to the left to reduce or eliminate the curve, then drag the top handle to create the corner. -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
