If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cannot convert dwg files
Hallo
I tried to convert dwg files in Visio 2007 and always get this message: "The CAD Entity is not supported by the Visio CAD Converter" What happens ? Are there some layers missing? Thanks for help Susan |
#2
|
|||
|
|||
cannot convert dwg files
On Tue, 30 Mar 2010 01:19:01 -0700, Susanne Mohn
wrote: Hallo I tried to convert dwg files in Visio 2007 and always get this message: "The CAD Entity is not supported by the Visio CAD Converter" The DWG diagram might be in a version not supported by Visio, try saving the DWG file in an older version. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|