If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access Labels Maker Doesn't Work
Used to able to make labels from earlier editions of Access w/o any problems.
Since updating to "2007" I wind up with messages popping up and little boxes asking for parameter values for Trim even though I use the Label Wizard and would assume "the Wizard" would/should take care of ninty gritty details. I'm a "user" not a developer or programer. How do I fix this problem so I can just print some labels? -- elderuser |
Thread Tools | |
Display Modes | |
|
|