If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Avery 5160 Help
I downloaded the template for the 5160 from the MVP template site but I am
wondering how do I enter information in all of the spaces other then the top 3. See, after I downloaded it, I went to enter the information and was successful in doing so, but only in the top 3 spaces. Any help? |
#2
|
|||
|
|||
Avery 5160 Help
Are all your labels going to be alike? Are you merging?
If not, setup your page this way: ..19" side margins ..5" top & bottom In the grid guide arrange tab, 3 columns, 10 rows .13" horizontal gap zero vertical gap. You can look at the 5160 label in page setup, click adjust label printing and verify the measurements give above. -- Mary Sauer MSFT MVP http://office.microsoft.com/ http://msauer.mvps.org/ news://msnews.microsoft.com "Jesse" wrote in message ... I downloaded the template for the 5160 from the MVP template site but I am wondering how do I enter information in all of the spaces other then the top 3. See, after I downloaded it, I went to enter the information and was successful in doing so, but only in the top 3 spaces. Any help? |
#3
|
|||
|
|||
Avery 5160 Help
All of my labels are going to be different, and there is no merging.
"Mary Sauer" wrote: Are all your labels going to be alike? Are you merging? If not, setup your page this way: ..19" side margins ..5" top & bottom In the grid guide arrange tab, 3 columns, 10 rows .13" horizontal gap zero vertical gap. You can look at the 5160 label in page setup, click adjust label printing and verify the measurements give above. -- Mary Sauer MSFT MVP http://office.microsoft.com/ http://msauer.mvps.org/ news://msnews.microsoft.com "Jesse" wrote in message ... I downloaded the template for the 5160 from the MVP template site but I am wondering how do I enter information in all of the spaces other then the top 3. See, after I downloaded it, I went to enter the information and was successful in doing so, but only in the top 3 spaces. Any help? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AVERY 5160 LABEL | MISSMILLY | New Users | 4 | January 29th, 2006 05:46 PM |
what is the difference between Avery 5160 and 8160 | newOfficeUser | General Discussions | 3 | October 27th, 2005 01:10 AM |
Default issue -- Mailing Labels for Avery 5160 | Nyla K | Setting Up & Running Reports | 4 | October 10th, 2005 10:25 PM |
Avery 5160 | teddkilroy | General Discussion | 2 | September 19th, 2005 05:51 PM |
How do I set up address data for labels (Avery 5160)? | Triathlete | Mailmerge | 2 | June 17th, 2005 12:13 AM |