If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
format a buried data series
I have one data series that is buried in the floor of a chart. I want
to select the data series and assign it to the secondary axis. I used to be able to select the individual data series in a menu ( I think) even if it was not selectable on the chart because it was buried in the floor. I looked around on the ribbon but cannot find it. any ideas? |
#2
|
|||
|
|||
format a buried data series
I found it. Select a chart then the layout tab of the Chart Tools
ribbon, in the upper left hand corner of the ribbon there is a drop down to select the different areas of the chart and the individual data serieses. On Nov 3, 9:59*pm, Robert H wrote: I have one data series that is buried in the floor of a chart. I want to select the data series and assign it to the secondary axis. *I used to be able to select the individual data series in a menu ( I think) even if it was not selectable on the chart because it was buried in the floor. *I looked around on the ribbon but cannot find it. any ideas? |
Thread Tools | |
Display Modes | |
|
|